Canon Service Tool is a device used to reprogram printers, after changing factors such as Logic Board Ass’y, Waste Ink Absorber, Print Head, etc. Errors on Canon printers are divided into two agencies particularly “Operator Call Error” and “Service Call Error”. Operator Call Error is an error that can be resolved by way of the operator or consumer such as paper jam, no paper, ink cartridge in an incorrect position, ink cartridge no longer installed, etc. Whereas Service Call Error is an error that requires immediate restoration via the Service Center, such as waste ink absorber is full error code.
To reset the printer Canon can be executed in two ways, particularly guide reset and Service Tool reset. For guide resets, examine the Reset Canon Printers Manually post, whilst resetting with the Service Tool will be mentioned in the publish below.
In the case of “Waste ink absorber is full”, the use of the Service Tool to reset the waste ink counter will be high quality if the waste ink absorber is changed with a new one. canon printer reset The use of Service Tools that are no longer accompanied with the aid of aspect replacement, will purpose new issues in the close to future. The use of the Service Tool to reset the waste ink counter will be wonderful after now changing the waste ink absorber.
The Canon Service Tool can be used if the printer is in the Service Mode position. If the printer is in the person mode position, the Service Tool can’t be used or an error message seems when used. The Canon Service Tool can be used for various kinds of printers, and when the Service Tool does no longer guides the printer, an error message will show up as a signal that the Service Tool does no longer help the printer. Canon Service Tool is a transportable utility that can be used except having to install it first.
The Canon Service Tool can be used if the printer is in the Service Mode position. To enter Service Mode, you need to press the Stop/Reset/Resume/Cancel button (adjust your printer, what buttons are available), and the Start/Power/On/Off button (adjust your printer, what buttons are available) routinely alternating in a sure amount. To enter Service Mode, every printer has a unique way, however, the steps are nearly the same.
The following are the steps to enter Service Mode.
-
The electricity cable is connected, the USB cable is related to the printer and PC/Laptop, and the printer is off.
-
Press and keep the Stop/Reset/Resume/Cancel button (adjust your printer, what buttons are available)
-
Press and keep the Start/Power/On/Off button (customize your printer, what buttons are available).
-
Release the Stop/Reset/Resume/Cancel button. For the Start/Power/On/ Off button nonetheless on preserve (don’t release)
-
Press the Stop/Reset/Resume/Cancel button x times, then launch the Start/Power/On/Off button (read; how to do step 5)
-
After the printer is in Service Mode, open the Canon Service Tool.
How to do step 5
For example, the printer being repaired is Canon MG2100, and the x cost is 5 times. So the way to do step 5 is as follows.
Press and launch the Stop/Reset/Resume/Cancel button four times, then press and maintain the Stop/Reset/Resume/Cancel button 1 time, then launch the two buttons concurrently (Stop/Reset/Resume/Cancel, and Start/Power/On/Off)
Note: If the mild stops blinking and turn green, the printer is in Service Mode. If the lights preserve flashing or flip orange, the printer failed to enter Service Mode. Turn off the printer and repeat the manner to enter Service Mode.
The cost of x adjusts the kind of printer that is fixed. For canon printer reset in well-known x values are two and 5. But there are additionally x values that are three times, such as iP90, i70, i80. For the fee x = 6 times, it is used to disable error detection on the scanner and begin the computer in provider mode. For example: on the Canon MG2100, the cost of x is 5 times. To disable error detection on the scanner, the x cost is 6 times.
#canon printer reset
